DmOffset

SCPI Command :

[SENSe]:PROBe<pb>:SETup:DMOFfset

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get(probe=Probe.Default) → float

# [SENSe]:PROBe<pb>:SETup:DMOFfset
value: float = driver.applications.k6Pulse.sense.probe.setup.dmOffset.get(probe = repcap.Probe.Default)

Sets the DM-mode offset. The setting is only available if a modular probe in DM-mode is connected to the FSW. If the probe is disconnected, the DM-mode offset of the probe is reset to 0.0 V. Note that if the offset for DM-mode or CM-mode is changed, the offsets for the P-mode and N-mode are adapted accordingly, and vice versa. For details see ‘Using Probes’.

Parameters:

probe – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Probe’)

Returns:

dm_offset: Voltage offset between the positive and negative input terminal Unit: V

set(dm_offset: float, probe=Probe.Default) → None

# [SENSe]:PROBe<pb>:SETup:DMOFfset
driver.applications.k6Pulse.sense.probe.setup.dmOffset.set(dm_offset = 1.0, probe = repcap.Probe.Default)

Sets the DM-mode offset. The setting is only available if a modular probe in DM-mode is connected to the FSW. If the probe is disconnected, the DM-mode offset of the probe is reset to 0.0 V. Note that if the offset for DM-mode or CM-mode is changed, the offsets for the P-mode and N-mode are adapted accordingly, and vice versa. For details see ‘Using Probes’.

Parameters:

• dm_offset – Voltage offset between the positive and negative input terminal Unit: V

• probe – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Probe’)