End

SCPI Command :

CALCulate<n>:HOPDetection:PNOise:OFFSet:END

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get(window=Window.Default) → float

# CALCulate<n>:HOPDetection:PNOise:OFFSet:END
value: float = driver.applications.k60Transient.calculate.hopDetection.pnoise.offset.end.get(window = repcap.Window.Default)

Defines the end of the measurement range for phase noise results as an offset in seconds from the hop end. This command is only available if the reference is EDGE (see method RsFsw.applications.k60Transient.calculate.hopDetection.pnoise.reference.set() ) .

Parameters:

window – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Calculate’)

Returns:

time: Unit: S

set(time: float, window=Window.Default) → None

# CALCulate<n>:HOPDetection:PNOise:OFFSet:END
driver.applications.k60Transient.calculate.hopDetection.pnoise.offset.end.set(time = 1.0, window = repcap.Window.Default)

Defines the end of the measurement range for phase noise results as an offset in seconds from the hop end. This command is only available if the reference is EDGE (see method RsFsw.applications.k60Transient.calculate.hopDetection.pnoise.reference.set() ) .

Parameters:

• time – Unit: S

• window – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Calculate’)