Signal#

SCPI Command :

[SENSe]:MIXer:SIGNal
Commands in total: 1
Subgroups: 0
Direct child commands: 1
get ( ) → State
set ( arg_0: State ) → None
# [SENSe]:MIXer:SIGNal
# get:
value: enums.State = driver.applications.k18AmplifierEt.sense.mixer.signal.get()
# set:
driver.applications.k18AmplifierEt.sense.mixer.signal.set(arg_0 = enums.State.ALL)

Specifies whether automatic signal detection is active or not. Note that automatic signal identification is only available for measurements that perform frequency sweeps (not in vector signal analysis or the I/Q Analyzer, for instance) .

Parameters:

arg_0 – OFF | ON | AUTO | ALL

  • OFF | ON | AUTO | ALL:

  • OFF: No automatic signal detection is active.

  • ON: Automatic signal detection (Signal ID) is active.

  • AUTO: Automatic signal detection (Auto ID) is active.

  • ALL: Both automatic signal detection functions (Signal ID+Auto ID) are active.