ConMeas#

SCPI Command :

INITiate:CONMeas
Commands in total: 1
Subgroups: 0
Direct child commands: 1
set ( ) → None
set_with_opc ( opc_timeout_ms: int = -1 ) → None
# INITiate:CONMeas
# set:
driver.applications.k17Mcgd.initiate.conMeas.set()
# set_with_opc:
driver.applications.k17Mcgd.initiate.conMeas.set_with_opc(opc_timeout_ms = 3000)

Restarts a (single) measurement that has been stopped (using method RsFsw.abort CMDLINKRESOLVED]) or finished in single sweep mode. The measurement is restarted at the beginning, not where the previous measurement was stopped. As opposed to [CMDLINKRESOLVED applications.k10Xlte.initiate.immediate.perform() , this command does not reset traces in maxhold, minhold or average mode. Therefore it can be used to continue measurements using maxhold or averaging functions.

set_with_opc() does the same as set(), but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout to set the timeout value.

Parameters:

opc_timeout_ms – Maximum time to wait in milliseconds, valid only for this call.