Level

SCPI Command :

[SENSe]:ADJust:LEVel

class LevelCls

Level commands group definition. 2 total commands, 1 Subgroups, 1 group commands

set() → None

# SCPI: [SENSe]:ADJust:LEVel
driver.applications.k14Xnr5G.sense.adjust.level.set()

Initiates a single (internal) measurement that evaluates and sets the ideal reference level for the current input data and measurement settings. This ensures that the settings of the RF attenuation and the reference level are optimally adjusted to the signal level without overloading the FSW or limiting the dynamic range by an S/N ratio that is too small.

set_with_opc(opc_timeout_ms: int = - 1) → None

# SCPI: [SENSe]:ADJust:LEVel
driver.applications.k14Xnr5G.sense.adjust.level.set_with_opc()

Initiates a single (internal) measurement that evaluates and sets the ideal reference level for the current input data and measurement settings. This ensures that the settings of the RF attenuation and the reference level are optimally adjusted to the signal level without overloading the FSW or limiting the dynamic range by an S/N ratio that is too small.

Same as set, but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout_set() to set the timeout value.

param opc_timeout_ms

Maximum time to wait in milliseconds, valid only for this call.

Cloning the Group

# Create a clone of the original group, that exists independently
group2 = driver.applications.k14Xnr5G.sense.adjust.level.clone()

Subgroups

• All