RefLevel

SCPI Command :

[SENSe]:POWer:ACHannel:PRESet:RLEVel

class RefLevelCls

RefLevel commands group definition. 1 total commands, 0 Subgroups, 1 group commands

set() → None

# SCPI: [SENSe]:POWer:ACHannel:PRESet:RLEVel
driver.applications.k10Xlte.sense.power.achannel.preset.refLevel.set()

This command determines the ideal reference level for the current measurement. This automatic routine makes sure that the that the signal power level does not overload the FSW or limit the dynamic range by too small a S/N ratio. To determine the best reference level, the FSW aborts current measurements and performs a series of test sweeps. After it has finished the test, it continues with the actual measurement. To get a valid result, you have to perform a complete sweep with synchronization to the sweep end. This is only possible in single sweep mode.

set_with_opc(opc_timeout_ms: int = - 1) → None

# SCPI: [SENSe]:POWer:ACHannel:PRESet:RLEVel
driver.applications.k10Xlte.sense.power.achannel.preset.refLevel.set_with_opc()

This command determines the ideal reference level for the current measurement. This automatic routine makes sure that the that the signal power level does not overload the FSW or limit the dynamic range by too small a S/N ratio. To determine the best reference level, the FSW aborts current measurements and performs a series of test sweeps. After it has finished the test, it continues with the actual measurement. To get a valid result, you have to perform a complete sweep with synchronization to the sweep end. This is only possible in single sweep mode.

Same as set, but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout_set() to set the timeout value.

param opc_timeout_ms

Maximum time to wait in milliseconds, valid only for this call.